Freemax Marvos X Pro 100W kit – now it’s definitely a box mod
Today we arrived again from Freemaxvape camp. For the most part, it replicates the Freemax Marvos X device we already know – Freemax Marvos X Pro.
Dimensions: 89 x 32.8 x 30.9mm
Case material: metal + plastic
Power: 1 x 18650
Chipset: FM CHIP 2.0
Power: 5 – 100W
Voltage range: 0.7 – 4.2V
Operating mode: Power, VPC, Smart, BYPASS
Supported resistance: 0.1 – 3.0Ω
When I started understanding and looking for differences in versions, a strange story happened – the first time this happened to me – and I found almost no differences. In the article above, I assumed that the device has a standard 510 connector, which is actually a box module.
However, it turns out that’s not the case at all – a big thanks to the developers for “such a detailed introduction” – the predecessor turned out to be little more than a smart Pod mod, but today’s guest differs from it in that it is a Thoroughbred Box mod.
The novel design of the POD tank is standard – cartridge + metal base with standard 510 connector. The capacity is good and the top filling is a lid with a sliding structure.
The replaceable evaporators that power the novelty are the same – the MS Coil series. Even in the kit, there will be several sub-ohm replicas of the same predecessors as the Pod system.
The adjustment of the tightening strength is achieved in a standard way – a swivel ring on the metal base of the tank. The box mod itself is an almost exact replica of the predecessor pod system, but it is now certain that a full-fledged 510 connector exists.
Even the size of the device is almost the same – not that small, by the way. But the proposed color scheme is a bit different – our Freemax today made it a little “cheerful”.
The control panel hasn’t changed either – the standard set of elements plus the familiar physical device locking slider. Again, the body is lit “from all sides” and the glow settings are very detailed – effects and colors.